I have a Tilton 3 disc clutch with new Ace 1 1/8 10 spline discs. Can also supply Ford 1 1/16 ten spline.
$400 shipped in the lower 48
www.oneyracing.com
New Eagle 3.250 stroke crankshaft. This had been installed in an engine, but never fired. Weighs right at 52 pounds and has 2.449 main journal, 2.100 rod journal and 1.990 rod journal width. This is for two piece rear main seal small block Chevrolet and recommended for engines up to 1500...
Ultra light weight Bryant billet crankshaft with 3.255 stroke, 2.250 (302) mains, 1.850 rod journal, 1.825 rod journal width and only weighs 34 3/4 pounds. Came out of a 351 Windsor block with the 2.250 mains.
$825 OBO
See pictures at www.oneyracing.com
Very nice dry sump oiling system for small block Chevy. It includes a nice Weaver 5 stage dry sump oil pump with SBC mounts, Stef's stainless steel dry sump oil pan that includes all of the bottom access plugs, manifold with four -12AN in and one -16AN out, Oberg UFO bllet oil filter, three...
Brand new Ace triple disc 7.25" with 1 1/8" 10 spline discs. Includes brand new button flywheel for small block Chevy with two piece rear main seal.
$550 shipped in the US
You can see pictures at www.oneyracing.com
Brand new 53-501 Tilton magnesium bellhousing for small block Chevy. Works with tilton or quartermaster 153 tooth flywheels.
$400 OBO
You can see pictures at www.oneyracing.com
I have a used Tilton triple disc clutch for sale. All cleaned and checked with new Ace 1 1/8" 10 spline discs.
$385 w/o flywheel
$435 w/ new SBC 2 piece rear main seal button flywheel
you can see more pictures at www.oneyracing.com
I have a very nice set 6 inch Carrillo rods. These came out of one of our SBC SB2.2 engines. They have the SPS Carr bolts, .940 wide on the big end and are 2.017 rod journal to work on the 1.888 crankshaft.
$525
You can see more pictures at www.oneyracing.com
Includes Quartermaster bellhousing with throwout bearing, QM V Drive triple disc clutch with new 10 spline discs, Race Proven mini starter, QM flywheel and ARP flywheel bolts.
$999 OBO
See pictures at www.oneyracing.com
I have a nice LA Kryptonite crankshaft for small block Chevy that has been magged, polished and is ready to install. Specs are:
3.280 stroke
2.300 mains
1.900 rod journal width
2.000 rod journal
Only 40 1/2 pounds
You can see pictures at www.oneyracing.com
$850
MSD 6632 HVC ignition box with built in rev limiter. Includes modules for 6000, 7000, 7400 and 8000 rpm.
$175 shipped in the US
See pictures at www.oneyracing.com
R351 /1 R352 High flow two piece SBF water pump. Fits right over the DannyB and other belt drives.
$125 shipped in the US
See picutres at www.oneyracing.com
I have a really nice six stage dry sump manufactured by Frank Weiss Racing Components. Came off of a small block Chevy and is a rotor style pump with the front pulley. $850
If you're looking for something a little lower in price I also have a six stage Barnes that also came off of a small...
SB2.2 small block Chevy heads with 2.180 intake and 1.600 exhaust valves. Includes all of the locks, retainers, only 13 of the lash caps, valve springs and a large assortment of springs seat shims. Head plugs are also included. Of course, I would recommend a valve job prior to use, but this is...