Search results

I have seven used wheels all are a little dinged up but all usable. Non-headlock: 1 -12" with 4" offset, 1 -14" with 5" offset Beadlock: 1 - 12" with 2" offset, 1 -12" with 4" offset, 3 - 14" with 5" offset Sell the whole lot for $350.00. Thanks, Greg 314-707-5339

This is a new never been fired 383 SBC it has a eagle forged crank, eagle H beam rods with rod bolt upgrade, ross lightweight pistons, comp cams 4/7 swap roller cam, crower severe duty roller lifters, comp cams push rods, cloyes hex-a-just timing chain, brodix 18XSP heads ported with manley...

If possible a picture or two would be great! I can't get there tonight but Ray was my favorite driver as a youngster and that red willy's was my favorite of his cars.

Bobby I sure hope for speedy recovery! And remember those good days when he was driving the #27 gremlin. Please keep the form board updated on his progress. Greg

I have a 18 degree 383 this is a new engine built for a UMP modified. I'm getting out of racing will deal in the St. Louis area 314-707-5339.

I have a new race ready sbc 383 with GM high nickel 350 block, eagle 3 3/4" crank & eagle 6" h beam rods with rods bolt upgrade, JE pistons with lightweight pins, comp cams roller cam with 4/7 swap, crower severe duty roller lifters, comp cams push rods, cloyes billet timing chain, brodix 18...

Used Comp Cams Roller part# 12-923-9 great short track cam for bigger displacement engines with good flowing heads. With PBM roller lifters and comp cams push rods and stainless steel 1.5 ratio roller rocker arms with alum stud girdle. This stuff is in nice condition great setup for 23 degree...

Contrats Donny! I hope 2011 is a very impressive year!

I have a '06' impressive in excellent condition with '09' rear suspension updates including a lightweight QC and '10' front end updates. I would consider selling as a roller or without the rear end. You can contact me at 314-698-8560.

I see this add is a couple of months old is this motor still for sale?

Can you forward more information on the carb? Like model and size? Or you can call me at 314-698-8560.

I have a set of Brodix 18X spreadport heads for sale they are freash from the machine shop ready to bolt on. They have stainless valves with chome molly retainers and keepers. One head has some nicks on he surface around 2 of the combustion chambers. They are super fical and won't inpact...

400 Block I have a couple of 400 blocks one is a 2 bolt .030 over, the other is a std. bore 4 bolt. You can reach me at 314-698-8560.

Marc's cell is 618-2953058.

My dad Lyle Sinn ran sportsman with Allied in the sixties & seventies, then modfieds in the early eigthies. He helped Larry Jones and his brother Mike Sinn get started they both ran sportsman and modifieds in the late seventies & eigthies. He also helped Marc McClintock get started with his...

I don't think you will find any better guy in racing to work with than Don at least that as been my experience. Greg Sinn #14s

Yes I would like to take advantage of the pratice sessions. 14s modified

I have a 06 pierce complete and a 06 impressive complete call for details 314-229-9815.

Jeff Yes those center steer cars were alot of fun, I wish there was some place around here to race an updated version. Greg Sinn

That car started out as #2 with Lyle Sinn driving and then was #27 with Bobby Bizelli driving, then #11 with Greg Sinn driving.