Search results

jbe thnx for the info on warrensberg,i will probably run their but not my daughtert,not if it is the way you say..well just have to go see how it is and go from their.good day!

jyi thnx for the info i refine,will see ya there.thnx again! oh what about the billet rod,do they allow them,all my motors are setup like that now and just wanna be legal.thnx again!

directions where is this track located?we will be down some and also you guys allowing billet rods?

sedailia the track in warrensberg is ran by the same poepel that run sedailia so i dont even know if it will be worth goin to warrensberg..i havent been there,so i cannot say whether they are good nor bad..we had planned on runnin there some this year but we will have to see..also jbe what is...

jbe if your talkin to me,i am beating on them for somethin they did do!!!!!!!!!as far as the 600 to win,you are right on that,it was 1000 purse,600 being to the winner and so on...

sedailia i was not to impressed with them,we ran there last weekend and was up to fourth(from dead last) and had to go to the back of the pack because the guy behind us was pushin the pack and pushed me passed another car on the restart,after i went to that back,the third place car did the very...

josh got you email,sent you a reply.thnx!

engines kloos motor is sold,will take $400 for the gerber,it is fresh and runs well.

will they be running this weekend and does anyone know when they start??need to know asap,would like to run their tomorrow...thnx alot!

clutch that will deffinately put ya in the rpm range:D :D will you have your scales at flickerwood?

car check pm...thnx

i have two engines for sale,both are fresh and run good,complete with headers and carbs.can hear run....I GOT THEM IN ON TRADE,FRESHENED THEM AND ARE READY TO GO.. KLOOS STOCKER(M BLOCK,,STD BORE)-------$450 GERBER RACE ENGINES STOCKER(RAPTOR BLOCK,,15 OVER BORE)--$450

will the billet rod rule be in effect at flickerwood??this will be our first race out for 2004 and want to make sure as all of our motors now have billets now thanx to all the tracks goin to that new rule...also will belleville and greenville and coulterville have this rule for 2004 season as...

swap meet where is coulterville?how far from pevely missouri?thnx alot!

rods i never said an engine that turns more rpms creates more power.these engines create more power when you get them in the powerband by using different cams and settings.some engines run good at low rpm cause that is the powerband the cam is setup at.some engines run good at high rpm cause...

motors 34fmf, the reason that two motors that are identical will run different is because there are none two that will come out the same when they are done being built.for one the blocks are totally different.some have better castings then the others.blocks with better castings will flow...

newbie advice if you want to get in to dirt racing,let us know we would be glad to meet you at the track and show you the ropes,even let ya try one of our karts out to see how ya like it for a few laps.come on down to our pit if your ever at the track we will be glad to show you what all goes...

billet rods there are alot of different lenght rods for stk application.i been thinkin about this and heres what i come up with.i say wka says that we all have to run the stk length and stroke arc rod.and make it the spec rod.

rods billet rods are a little heavier,but not so much that they dont give a performance gain.we have as well as many engine builders do plenty of dyno sheets with billet rods pulling more horsepower for the simple fact you can pull more power out of the engine with that rod.there has been quite...

billet rods ok first things first.there is nothing wrong with our engines as far as having to turn 7200 rpms.doesnt matter weather we tun 6800 or 7200 they are still strong,but they pull alot harder and farther at 7200 but understand you also gotta have a chassis setup to where it will handle...