air pressure
'DOH
I have a 383 sbc. 13:1 comp. 4 bolt block 350, studded main caps. Scat crank. Eagle 6" rods. KB pistons, .284" dome. 7qt Oil pan with trap doors and scraper. There is a dent on right front lower, does not leak. Melling h/d oil pump. Flat-tapp cam (Engal). Molly push rods. Dubble roller timing chain. 400 balancer, smaller dia flex plate. Competely balanced. Iron Eagle heads, 215 runner, I forget the valve size, possible 2.02/1.94??? sorry don't remember. 3 angle valve job.
screw in studs and guide plates. Alum roller rockers. Angled plugs. Air gap intake. 4brl spacer 1". Motor was freashened, ran 2 nights and then sat for a back up for 2 years. I have inspected engine with bore scope and removed
rocker covers, no rusting seazing ect. Motor Turns over great. Make a very good IMCA motor, or beginer UMP on short track. This motor has a ton of bottom end to about 7000rpm. Motor has +/- 2500 laps on it total.
Welcome to inspect, before purchase. Will not be dissapointed.
$3,200.00 obo.. Call 573-768-4973 no calls after 9:30 pm central time please
screw in studs and guide plates. Alum roller rockers. Angled plugs. Air gap intake. 4brl spacer 1". Motor was freashened, ran 2 nights and then sat for a back up for 2 years. I have inspected engine with bore scope and removed
rocker covers, no rusting seazing ect. Motor Turns over great. Make a very good IMCA motor, or beginer UMP on short track. This motor has a ton of bottom end to about 7000rpm. Motor has +/- 2500 laps on it total.
Welcome to inspect, before purchase. Will not be dissapointed.
$3,200.00 obo.. Call 573-768-4973 no calls after 9:30 pm central time please
