Grossman#2
#2
I have a 1987 Chevy Astro Van for sale. This has tons of new parts. It has a mild 305 with lots of chrome and full air ride suspension. Suspension consists of:
New slam specialties RE7 bags all around. New upper and lower control arm bushings. New upper and lower ball joints. New brake rotors, brake pads, brake calipers. Has new DJM drop spindles. Suicidedoors.com bag cups. New wheel bearings and seals. Has a Suicidedoors.com triangulated four link in the rear with super pivot bushings. 8in suicidedoors.com step notch. Suicidedoors.com bag brackets. Rear end is out of an old chevy. Has all new brakes also.
Motor consists of:
Mild 305 with low miles. Has new timing cover gasket, valve cover gaskets, intake gaskets, new edelbrock performer intake, new chrome moroso valve covers, new summit aluminum pulleys, new chrome timing cover, new chrome alternator and bracket, new chrome water pump, has all chrome engine bolts with chevy bowties on the heads. Transmission is a borgwarner five speed with a new centerforce stage 2 clutch. tranny has low miles also. new u-joints and caps.
Body consists of:
Shaved front doors, sliding door, and rear door all in primer, custom roll pan started (one side needs finished), drivers side rocker panel has been replaced, pass side needs replaced but I have a new one. Front fenders are in primer and dent free. needs a hood and grill. front bumper is shaved and license plate box has been frenched in. still needs some work.
Interior consists of:
no carpet from factory, has two camaro buckets that need mounted, back factory bench seat which has had the frame sectioned to match the height of the buckets. factory door panels and dash. This van is one of 1500 made between 1985 and 1989. Five speeds are very hard to find.
The bad:
The motor needs a carb, headers, dist., starter, plugs, wires, motor needs wired up ( wires are all figured out just need connected), drive shaft needs put in, rear brake lines need ran, fuel lines, fuel cell, needs a compressor, tank, valves, airline. If you are interested email me at KHE_88_00@hotmail.com or call me at 319 524 5675. the van is located in southeast iowa about 2.5 hours from st louis. I really want a nice hornet to start racing again. lets work somethin out
Heres some pics. If you want more just email me I have a ton from when I first got it till now. I also have a stripped out 95 neon that i would throw in if it was a good offer. neon runs and is a five speed.
New slam specialties RE7 bags all around. New upper and lower control arm bushings. New upper and lower ball joints. New brake rotors, brake pads, brake calipers. Has new DJM drop spindles. Suicidedoors.com bag cups. New wheel bearings and seals. Has a Suicidedoors.com triangulated four link in the rear with super pivot bushings. 8in suicidedoors.com step notch. Suicidedoors.com bag brackets. Rear end is out of an old chevy. Has all new brakes also.
Motor consists of:
Mild 305 with low miles. Has new timing cover gasket, valve cover gaskets, intake gaskets, new edelbrock performer intake, new chrome moroso valve covers, new summit aluminum pulleys, new chrome timing cover, new chrome alternator and bracket, new chrome water pump, has all chrome engine bolts with chevy bowties on the heads. Transmission is a borgwarner five speed with a new centerforce stage 2 clutch. tranny has low miles also. new u-joints and caps.
Body consists of:
Shaved front doors, sliding door, and rear door all in primer, custom roll pan started (one side needs finished), drivers side rocker panel has been replaced, pass side needs replaced but I have a new one. Front fenders are in primer and dent free. needs a hood and grill. front bumper is shaved and license plate box has been frenched in. still needs some work.
Interior consists of:
no carpet from factory, has two camaro buckets that need mounted, back factory bench seat which has had the frame sectioned to match the height of the buckets. factory door panels and dash. This van is one of 1500 made between 1985 and 1989. Five speeds are very hard to find.
The bad:
The motor needs a carb, headers, dist., starter, plugs, wires, motor needs wired up ( wires are all figured out just need connected), drive shaft needs put in, rear brake lines need ran, fuel lines, fuel cell, needs a compressor, tank, valves, airline. If you are interested email me at KHE_88_00@hotmail.com or call me at 319 524 5675. the van is located in southeast iowa about 2.5 hours from st louis. I really want a nice hornet to start racing again. lets work somethin out
Heres some pics. If you want more just email me I have a ton from when I first got it till now. I also have a stripped out 95 neon that i would throw in if it was a good offer. neon runs and is a five speed.
