Nice Used Callies XL Magnum Crank Built In 2015. For 350 GM Small Block. 3.480 stroke, 2.1 Pins, 5.7 rods, 1892 bob weight. Can Take additional photos if needed. Removed from my 377 dart block due to an oil leak / rear main bearing failure. Magnafluxed good ! Selling because I could not find...
Four bare housings. Two of them are 60 inches, and the other are 58 inches.
Three 31 spline axles, 5x5 1/2 bolt pattern
Two 28 spline axles 5x5 bolt pattern
Two 28 spline axles 5x4 1/2 (or maybe its 4 3/4 I don't remember)
Make offer on any or all
Two blocks from the early 70's. Both 2 bolt mains. One stock bore, one .030" over.
Two stock cast cranks. One unturned, one turned .010"
Three sets of 882 heads off of 350's
One set of 882 heads off of 400
One set of 462624 heads
One set of stock rods. Never been reconditioned...
I have four or five ford nine inch housings with axles. Never going to use them. Located 40 miles north of Alton, IL. Some 31's and some 28's. Make offer.
These are alot heavier duty than a saginaw three speed. If you think you mite have one let me know and I can tell you how to measure the difference's on the cases.
New still in box, quarter master hydraulic throwout bearing. All shims for bearing and the ones that go behind retainer plate are included with instructions. Won't work with clutch we are using. Fits Saginaw, Muncie, Jerico, T-10, you get the idea. Make offer .