IMCA Dry Sump Late Model Engine by Shepherd Engine Development
- Purchased NEW in March of 2015
- 10 Races on Engine (2 wins in 2015)
- DART SHP SBC Block
- 50mm camshaft
- T&D Shaft Rockers
- IMCA Spec cylinder heads and intake
- Crane Distributor
- Pro Pan Dry Sump Oil Pan
- Welded Aluminum...
This item has been sold, no longer available
454 Chevy Big Block
Std. bore 2 Bolt Main Block
Oven cleaned and steel shot blasted
Magnafluxed (OK)
Crankshaft
H-Beam Rods
JE Flat Top Pistons +.060
Rectangular Port GM Casting # 990 Iron Cylinder Heads (fully ported)
Stainless Valves
Roller Spring...
Dart Block
Airflow Research Heads
Callies Crank
Lunati Billet Rods
JE Pistons
AFR Shaft Rockers
MSD Adjustable Collar Dist
Jim Evans Holley 750 Carb
Schoenfeld Headers
Motor comes ready to bolt in car with oberg, oil cooler, water pump, pulleys, and fan.
Never been blown up and has 15...
Dart Block
Airflow Research Heads
Callies Crank
Lunati Billet Rods
JE Pistons
AFR Shaft Rockers
MSD Adjustable Collar Dist
Jim Evans Holley 750 Carb
Schoenfeld Headers
Motor comes ready to bolt in car with oberg, oil cooler, water pump, pulleys, and fan.
Never been blown up and has 15...
454 cubic inch Small Block Chevy engine run and dyno tested. Engine produced 630 horsepower at 5700 rpm and 630lbs/ft torque at 4500rpm on Mobil 93 octane fuel with 32 degrees total timing. This engine is intended for use in a jet boat or similar moderate rpm application where a large...