IMCA Dry Sump Late Model Engine by Shepherd Engine Development
- Purchased NEW in March of 2015
- 10 Races on Engine (2 wins in 2015)
- DART SHP SBC Block
- 50mm camshaft
- T&D Shaft Rockers
- IMCA Spec cylinder heads and intake
- Crane Distributor
- Pro Pan Dry Sump Oil Pan
- Welded Aluminum...
400 SMALL BLOCK CHEVY
Bare Block/Std. Bore
Hard to find 2-Bolt Main Block
Excellent block for Hi-Perf use or to install splayed caps.
*Block has been thermal oven cleaned & steel shot blasted
*Magnafluxed for cracks (OK-no cracks)
*Stripped of old cam bearings & oil galley plugs
*Block will make...
your v8 block race prepped ( cleaned & inspected, aline honed ,bore & torque plate honed ,decked with bhj block tru & freeze plugs &cam bearings installed ) $450.00 plus parts
give me a call at 573-562-7390 or look me up on facebook @ THE ENGINE SHOP.
454 cubic inch Small Block Chevy engine run and dyno tested. Engine produced 630 horsepower at 5700 rpm and 630lbs/ft torque at 4500rpm on Mobil 93 octane fuel with 32 degrees total timing. This engine is intended for use in a jet boat or similar moderate rpm application where a large...