help

[Racer 13T]

how do u figure wheel base when u have ur caster and camber setup in it. it says min 108 but mine is not cuz its bent but might be measuring wrong i thought it was from middle of wheel bearing to middle of rear end. any help appreciated thanks shawn

 

[Racer14K]

Center of wheel -to- center of wheel is correct but is not accurate unless the front wheels are perfectly straight. I take the grease fitting out of the lower ball-joint and skrew in a 1/4"x3" fine thread bolt. I then put a level against the front side of the axle tube so it is straight up and down. Measure from the same point on both bolts to the back side of the level and add half the diameter of the axle tube, this will be your wheel base length.

For this to be accurate front and rear wheels need to be at ride height. Doing it this way the measurments are not affected by the caster/camber difference between the left and right spindles.

 

[Racer 13T]

thank you