Recent content by 67jrpm

Not after any top secret info. Just a good starting point for springs, ride heights,left side%,rear%, bite. Thanks,any info is appreciated.

Thanks for the responses, I was just curious. I haven't seen anyone using one at the local tracks. I may experiment with it. Thanks again.

Hello,anyone ever used an electric cooling fan in a metric streetstock? Added an alternator over the winter and was thinking about an electric fan vs mechanical. Thanks for any input.

Thanks for the response, I currently have a hurricane intake with an adapter and I like the looks of the 2v. I just don't want to go backwards with this intake, but I think it's a better quality intake.

Has anyone used the edl-2901 2 barrel intake manifold? Just looking for some feedback for a new motor with a 2 barrel carb. Thanks

Bowtie heads are sold.

Bump

New in the box Dart 76 cc,USRA legal cylinder heads. Complete ready to bolt on,valves,springs,guide plates,screw in studs.part# 10024267. Heads were assembled at machine shop and are ready to use.$950.00 sbc bowtie heads,034 casting,complete and ready to bolt on. Fresh out of machine...

00000000000

Thank you guys for the input, the brake lines are steel. The rotors are not warped or have excessive runout. I have not tried bleeding the system in the way which you described. That sounds like a very good idea. I have bled throw out bearings on chevy pick ups in a similar manner. Thanks again...

Thanks for the help.

I traded for a modified during mid season, the car has floor mounted brake and clutch pedals. The problem is intermittently the front brakes will not work, soft pedal which feels like air in the system. I have eliminated the brake gauges, swapped master cylinders, replaced both front calipers...