Search results

Several six pin front and rear wheels,5x5 external slider top wing (useable),old torque tube with shifter mounted to it,six pin front spindles and hubs and a few other things.One price takes all.Make offer,it has to go!!!

Looking for a set of T-bucket headers for sbc std. port heads.They can have rust or damage as long as the upper tubes and flanges are in good shape.I'm not wanting a $300 set of headers because I'm going to cut them for my project. Can be the sprint style like in picture or the classic style.

Looking for a set of 32" steel wheel tubs for my project.

New in box radiator for a 65 Chevelle/Malibu with trans cooler.Inlet and outlet are on the passenger side.Bought it for my project but it won't work,too big.Selling for what I gave for it, $130.00, witch is still half price.

New in box radiator for a 65 Chevelle/Malibu with trans cooler.Both inlet and outlet on passenger side.Bought from a guy and can't use it for my project,too big.Selling for what I paid for it $130.00.That's still half price.

Looking for a factory automatic floor shifter and cable out of a 78-80 Camaro or Trans Am.Shifter cable not a biggie, but would be a plus!

Anyone have a reasonably priced 37 deg. flaring tool they want to sell?

Looking for a GOOD radiator,somewhere around 19"x22".Can't be any taller than 19" but could be a couple of inches wider.Prefer somewhere around the Farmington/Festus area.

Mike...Nothing to do with you, but I think the fans could hear you better if you had a megaphone.The PA system is junk.

Looking for 2 good 14" wheels,center caps and trim rings off an S-10 pickup.

I have an 89 1pc. main 350 block,crank and pistons,that is std bore.Will probably need bored,I don't know for sure, and crank turned,light knick on #1 journal.Will trade for something I may need.Let me know what you have!!!

If anyone around the Farmington/Park Hills area is scrapping a Chevy car or full size truck with a good firewall and trans tunnel back to the seat,please let me know.It may not work on my project but it's worth a shot.Older Oldsmobile and Pontiac may also work.

Looking for a good Sbc Edelbrock 7101 or ?? dual plane intake for a square base carb.

4-cyl.engine and trans out of a 1959 Morris Minor.If anyone is interested in it let me know before it goes to scrap.Engine is mostly complete and turns over by hand.Also have a complete front end minus rack.

Looking for a good,complete 350 around the Farmington area.2 or 4 bolt ok.Prefer older style with a 2 pc main.

Still looking for a good pair of stock coilsprings from a Pinto/MustangII.

Looking for a good stock 350 to rebuild for around $300.2 bolt main ok.No junk please!!

Looking for a set of the short headers for a S-10 V-8 swap.Would also take just the drivers side if priced right.If possible,please send pics to... higginsmotorsports@localnet.com

Mustang II power rack less rod ends...$50.00 Also looking for a good set of stock front coil springs from a Pinto/Mustang II.May trade?

Anyone heard how he was doing?:confused:There's been no mention of him that I know of.