350 010 4 bolt tanked and checked. Block checked for square and is very clean. Bored .30 over with matching Hyper SP617CP floater pistons with rings fitted by machine shop. Scat 5.7 rods. Have two sets of heads. One set of 333882 heads complete with leakdown valves, new springs, and 3/8 screw in studs and guide plates. With this head, block, and piston set up runs about 10.3 to 1 compression. Also have a set of bare heads 3932441 that have been checked and machined for guide plates adn screw in studs. Had the 441's as a back up but never used. Has a 7qt circle track pan with baffles. Has new timing chain and sprockets with cover.
To complete this motor you'd need a crank, bearings, oil pump, lifters, push rods, rockers, and cam of your design. I ran a HO 305 Lunati solid cam with this set up and was putting out about 420hp in a Modified. I ran this motor for about 30 laps and had tore down. Noticed a scuff on the crank and decided to get another motor rather than rebuild. Block is solid and great shape. Sitting without any intentions to put back together at this point. Have no need.
$450 gets everything I have for this motor including two intakes. A alum low rise stock off a 'vette #14007378 spreadbore and a Weiland 3000 alum low rise spreadbore that has been tanked and cleaned up. I have far more in this than what i am asking and just need out of my way at this point. For an additional $50 I'll add a Hi Rise G-Team intake.
Can leave message here or call 573-270-1801 and leave message. Located in Cape Girardeau, MO.
To complete this motor you'd need a crank, bearings, oil pump, lifters, push rods, rockers, and cam of your design. I ran a HO 305 Lunati solid cam with this set up and was putting out about 420hp in a Modified. I ran this motor for about 30 laps and had tore down. Noticed a scuff on the crank and decided to get another motor rather than rebuild. Block is solid and great shape. Sitting without any intentions to put back together at this point. Have no need.
$450 gets everything I have for this motor including two intakes. A alum low rise stock off a 'vette #14007378 spreadbore and a Weiland 3000 alum low rise spreadbore that has been tanked and cleaned up. I have far more in this than what i am asking and just need out of my way at this point. For an additional $50 I'll add a Hi Rise G-Team intake.
Can leave message here or call 573-270-1801 and leave message. Located in Cape Girardeau, MO.