1: New 6" Eagle rods, New Eagle crank, internally balanced, JE SRP pistons, Chrome moly rings, H bearings,New 6" lightweight balancer,New Champ Style oil pan,New solid motor mounts, New Mini Starter, used/ like new Holley Fuel pump..
2: Crane cams roller cam 630 lift 280/288 dur., PBM Roller Lifters, Manley Pro True Double Roller Timing Chain w/ Needle bearing roller, Roller cam button, Cam lock plate, Bronze tipped fuel pump rod, .080 wall .050 long Pushrods..
3: *FRESH* AFR Spread Port heads, 7/16 Screw in studs, AFR Guide plates, 2.08 Intake, 1.60 Exhaust valves, Harland Sharp 1:5 Roller Rockers, Howards Stud Gridles, BRODIX HVH Intake W/ Trutle, Ported by Stiegemeier out of St Louis MO.
4: 4150 830 CFM Holley Carb. " Like New " Screw-in air bleeds, reusable vinton gaskets, notched float, jet extensions, high flow throttle body with 1.75" bores, dual feed, with brass floats, 4 corner idle, high flow power valves, vinton-tipped needle .120" seat assembly, mechanical secondaries..
the base plate was fixed by a professional carb shop after it cracked the first time it was bolted down, Used very little, Works Great!!
Motor is assembled Oil pan to Intake, It has never been Fired! I will Disassemble It And sell It as I broke It up In the Discription.
Please Feel Free To Call With Any Questions
Neal (319) 795-0741
2: Crane cams roller cam 630 lift 280/288 dur., PBM Roller Lifters, Manley Pro True Double Roller Timing Chain w/ Needle bearing roller, Roller cam button, Cam lock plate, Bronze tipped fuel pump rod, .080 wall .050 long Pushrods..
3: *FRESH* AFR Spread Port heads, 7/16 Screw in studs, AFR Guide plates, 2.08 Intake, 1.60 Exhaust valves, Harland Sharp 1:5 Roller Rockers, Howards Stud Gridles, BRODIX HVH Intake W/ Trutle, Ported by Stiegemeier out of St Louis MO.
4: 4150 830 CFM Holley Carb. " Like New " Screw-in air bleeds, reusable vinton gaskets, notched float, jet extensions, high flow throttle body with 1.75" bores, dual feed, with brass floats, 4 corner idle, high flow power valves, vinton-tipped needle .120" seat assembly, mechanical secondaries..
the base plate was fixed by a professional carb shop after it cracked the first time it was bolted down, Used very little, Works Great!!
Motor is assembled Oil pan to Intake, It has never been Fired! I will Disassemble It And sell It as I broke It up In the Discription.
Please Feel Free To Call With Any Questions
Neal (319) 795-0741
