I am running a sportsman with a 355SBC, MSD 6AL, Blaster2 coil, Dart heads, HEI dist changed over for the MSD(no module, coil not in cap), 500CFM Carb, and 6.83 gear.
I looked at the tach Sat. in the corner to see what the Low RPM was and it was around 4200(when I looked right about the time I got on the gas). the cam is from 3200-7200 range.
I have changed to 3 different Carbs, changed and checked the timing chain/gears, tried some different timing settings.
Now for the problem:
the engine is laying down/ bogging at corner exit and I only get 6600 RPM flat footing it. Everyone else is leaving me at corner exit!!!!!
any suggestions?
Thanks
Jerry
P.S. I race at MCS
I looked at the tach Sat. in the corner to see what the Low RPM was and it was around 4200(when I looked right about the time I got on the gas). the cam is from 3200-7200 range.
I have changed to 3 different Carbs, changed and checked the timing chain/gears, tried some different timing settings.
Now for the problem:
the engine is laying down/ bogging at corner exit and I only get 6600 RPM flat footing it. Everyone else is leaving me at corner exit!!!!!
any suggestions?
Thanks
Jerry
P.S. I race at MCS