cheverolet engine parts

ModSquad3s

ModSquad3s

"Hillbilly Deluxe"
i have for sale 2 010 4 bolt blocks both one standard one 4.010-sold
i have a 509 400 block .20 over not a fresh bore with splayed caps not put on $125.00
i have a large journal steel 327 crank standard rods and mains has rust clean up .10 .10 $50.00
i have a set of 882 heads bare $50.00
i have a set of 461 heads bare-sold
2 sets of 624's $50.00 each
two sets of big block heads i knkow nothing about big blocks they are both complete with screw in studs and guide plates $100.00 each
misc big block aftermarket used cams $20.00 each pm for part numbers
edelbrock original torker manifold $75.00
email Dirtcar75@aol.com or call 618 920 2827
 
yes they do but i dont have the bolts for them or the front and rear cap i can get a front and rear cap but it will probly be a week or so
 
yes it does the caps havent been installed yet and i bought the block with no caps cause i was gonna put the splayed caps on and never did
 
i guess i could where u at im going to terre haute in two weeks would u be one the way or neer there
 
the big block heads are 346236 they are a set and they show 75-87 454 oval open 120cc chambers 225/116cc ports and the ther set is (3872702 and 3856206) they show 65-66 369 closed 97 cc chambers and the 509 block is two bolt with non installed splayed caps and the front and read cap is missing but i have a front and rear cap i can go get this week
 
You must log in or register to reply here.




Back
Top