S sports267 New Member Mar 4, 2011 #1 Anybody have any tips on getting steel axle tube out of the center section easier than having them pressed out
Anybody have any tips on getting steel axle tube out of the center section easier than having them pressed out
01cratefan Member Mar 4, 2011 #2 If you warm the center section where the tube fits in a little, and I mean a little with a torch it should swell enough to slip out.
If you warm the center section where the tube fits in a little, and I mean a little with a torch it should swell enough to slip out.
racin90 Well-Known Member Mar 5, 2011 #4 That works...just be careful. Center section is cast made...........and brittle. Just heat a little at a time....be patient. But it will work
That works...just be careful. Center section is cast made...........and brittle. Just heat a little at a time....be patient. But it will work