rear rotors

O

oldgold

New Member
i am looking for a rear rotor that wont have to be drilled to fit 4-3/4 bolt pattern ,heard s-10 rears late 90s or S-10 blazers which have more offset. any body dealt with this ? i am usiong metric calipers with weld on brackets thanks Rick
 
rotors

oldgold said:
i am looking for a rear rotor that wont have to be drilled to fit 4-3/4 bolt pattern ,heard s-10 rears late 90s or S-10 blazers which have more offset. any body dealt with this ? i am usiong metric calipers with weld on brackets thanks Rick
Click to expand...
I have a set of rotors that will fit either ford 9" or metric rear end, need to know the diameter of the axle hub, you may have to machine it down to fit inner rotor
 
4wd front s10 rotors is what I used with the 10 bolt rear end the gm axle flange does need to be turned down to fit inside the rotoe hat
 
rotors

rotors from a full size buick parkavenue fit ritght on and are abour 18.99 at Autozone try ar 84 ?
 
ohsomthin said:
rotors from a full size buick parkavenue fit ritght on and are abour 18.99 at Autozone try ar 84 ?
Click to expand...
isnt buick park avenue 84 rear wheel drive? need more specifics
heard chevy lumina would fit too. these are front wheel drive front rotors mounted on rear end.
 
Park Avenue switched for front wheel drive in late 83 i believe. Yes..almost any GM 4 3/4 pattern front wheel drive rotor will work without having to turn them. Any GM front wheel drive car 84 up will work. The s-10 style small truck 4wd version will work as well. May have to machine the inside a little to get it on. Really...just need to use a die grinder and bit to make it bigger. doesnt need to be perfect because the studs center the rotor. Just dont want to take too much off as it will make the rotor weak
 
You must log in or register to reply here.




Back
Top