Stock 9 inch seal question

W

wahooracing

Active Member
I am trying to find an inner housing seal for a stock 9 inch rearend, so the oil will stay in the center section. I know they make an inner seal for floaters but i haven't been able to findone for a stock housing. Does anyone know where i can find one? I seen on one car that instead of a regular seal they had a hardened foam of some sort stuck in the inner housing instead of a seal. Has anyone ever heard of anything like this? Or know where i can find anything like this? Thanks in advance Wahoo
 
I have cut a "washer" out of sheet metal, trimmed it and tack welded it in. Works very nice.
good luck,
Billy Molkenbur
 
I was wondering if this was the right one, thanks Howard and thanks wahoo for asking the question.
 
This one won't work it is for a i.d of 2 1/2 to 2 3/4. The inner diameter on my stock housing is around 3 inches.
 
wahooracing said:
This one won't work it is for a i.d of 2 1/2 to 2 3/4. The inner diameter on my stock housing is around 3 inches.
Click to expand...
Man, are you sure ??? maybe it tapers a little farther down the tube, I went to the "Seals It" site and they say it fits all 9 inch??? http://www.sealsit.com/axlehub.asp
If nothing else it would be real easy to make a sleeve that could be tack welded into the tube to accept the seal.....maybe give em a call
For more information:
call our Tech Center toll-free at 866.584.8422 or
email us at techcenter@sealsit.com
 
You must log in or register to reply here.




Back
Top