kRaZiE
K.D.C.S.
I have some smallblock chevy stuff that i got in a trade deal, and I have no use for this stuff. i also have two small blocks that i don't need. Make offers or possibly trade for whatever.... I just need this stuff gone.
1. 305ci. cast #460776 This is a 1976-79 motor that I pulled from an 83 K-5 Blazer. The heads are #14022601 (1980-86 heads). This was not running when I pulled it because it had no carb, water pumb, and no battery... but everything else is there (complete from intake to oil pan). I am unsure of the condition. Asking $50
2. 305ci. cast $14010202 heads are #14014416. This is a 1980-84 motor (high nickel block) that WAS RUNNING when pulled from an '84 Chevy Truck. It is complete intake to oil pan, could use a good tune-up or a re-build. Asking $300
3. Set of SBC Heads #333882 shaved 20 thousandths, roller rockers, Z28 springs... these are NICE heads ready to bolt on. Asking $300
4. Edelbrock Performer Intake (2101) like new. Asking $75
5. Cam and Lifter kit (i am not sure of the lift or duration of the cam) Hydraulic Lifters. The guy i got it from said he bought a new .515 and said that this cam is the step below his new one... However, I cant find any numbers on the ends where they usually are... The are in good shape. Asking $75 for cam and lifters
6. 1964-67 283ci. Crankshaft #GM11-3876768. 2 pc rear main, small journal, cast crank. USED but in good shape. Asking $50
1. 305ci. cast #460776 This is a 1976-79 motor that I pulled from an 83 K-5 Blazer. The heads are #14022601 (1980-86 heads). This was not running when I pulled it because it had no carb, water pumb, and no battery... but everything else is there (complete from intake to oil pan). I am unsure of the condition. Asking $50
2. 305ci. cast $14010202 heads are #14014416. This is a 1980-84 motor (high nickel block) that WAS RUNNING when pulled from an '84 Chevy Truck. It is complete intake to oil pan, could use a good tune-up or a re-build. Asking $300
3. Set of SBC Heads #333882 shaved 20 thousandths, roller rockers, Z28 springs... these are NICE heads ready to bolt on. Asking $300
4. Edelbrock Performer Intake (2101) like new. Asking $75
5. Cam and Lifter kit (i am not sure of the lift or duration of the cam) Hydraulic Lifters. The guy i got it from said he bought a new .515 and said that this cam is the step below his new one... However, I cant find any numbers on the ends where they usually are... The are in good shape. Asking $75 for cam and lifters
6. 1964-67 283ci. Crankshaft #GM11-3876768. 2 pc rear main, small journal, cast crank. USED but in good shape. Asking $50
