ujoint part number

S

sparky

Member
ok here it is monte carlo drive shaft 9 inch rear end anyone have part number to fit rear yoke on 9 inch, u joint part number
 
Which rear yoke do you have? Their are two common variations, one uses a smaller joint than the other. If your lucky you can come up with the yoke that uses the stock 2-3011 autozone u-joint. The other one yhey also stock, most of the guys know it as the bast***d joint. I dont remember the number off the top of my head, it's a 3-something, if you tell them to give you their last joint in sequence that is it. I will get the number for you tommorow.
 
If the shaft has outside snap rings there are two possibles.

3.622" yoke width / 1.063" cup dia. #1-0134

3.622" yoke width / 1.188" cup dia. #3-3140


If the shaft has the plastic injected keepers (inside snap rings on replacement joint) you will have four options depending on third member yoke width and cup diameter.

3.219" yoke width / 1.063" cup dia. #3-3130

3.622" yoke width / 1.063" cup dia. #2-1569

3.622" yoke width / 1.125" cup dia. #2-3049

3.622" yoke width / 1.188" cup dia. #2-1153
 
You must log in or register to reply here.




Back
Top