I've got two (2) 9" Ford floater housings for sale. Both are 60" hub to hub with the pinion centered.
Both came from LeftHander many years ago.
One has clamp-on two link brackets stitch welded in place (so they won't spin), and one had swing-arm style bearing birdcages on it that have been...
I have four (4) of these Winters 007 magnesium Wide 5 hubs that I'd like to sell, two (2) fronts and two (2) rears.
They are brand new and come in their original Winters boxes. New angular contact low drag ball bearings, spindle nuts, alum lug nuts, seals, dust caps, and drive plates are also...
That is the general idea, yes. :D
Might need a bit more than that get you a quote though.
If you just want to have your car scaled and looked over, and you can bring your own help (IE you don't need me to provide anyone to assist us), you're looking at $200/day (for up to 8hrs).
That's at my...
I usually quote by the job, depending on what you want/need done.
I've found that hourly rates tend to pile up a big bill a lot faster than it seems like it ought to, so the customer gets surprised (and pissed off).
Let me know what you're looking to have done (a PM or email is fine if you...
We ran a 5.43 up there in 2001 or 2002, but that was in an A-mod with a stout motor. Ran a 7,800 rpm chip in the MSD and bumped it just about every lap going into three.
Fulton was very "D" shaped back then, so the back straight (which really wasn't straight) ran like it was a little longer...
Is your racing program missing something? Can't seem to make your car faster or handle better, no matter what you do?
Do you need an engineer, but think that consultants are out of your price range?
If so, you are wrong.
I am an experienced racer, engineer, machinist, and fabricator...
Is your racing program missing something? Can't seem to make your car faster or handle better, no matter what you do?
Do you need an engineer, but think that consultants are out of your price range?
If so, you are wrong.
I am an experienced racer, engineer, machinist, and fabricator, and I...